No Ip Dhcp-Server - Siemens SIMATIC NET Configuration Manual

7.3.2.2

no ip dhcp-server

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
With this command, you disable the DHCP server on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
ip dhcp-server
Network protocols
7.3 DHCP server
307