Wlan Security Ssid - Siemens SIMATIC NET Configuration Manual

Security and authentication
10.2 WLAN
Result
The WEP or AES key is inserted in the key table.
Further notes
You display the settings with the
10.2.3.2

wlan security ssid

Description
With this command, you assign the SSID of a WLAN interface a security context.
Note
iPCF or iPCF-MC mode activated
If the iPCF or iPCF-MC mode is enabled, you can only select security context 1.
Requirement
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan security ssid <index (1-8)> context <ID (1-8)>
The parameters have the following meaning:
Parameter
index
context
ID
Result
The security context was assigned.
Further notes
You create a security context and change to the security context configuration mode with the
command
You display the setting with the
404
show wlan security <wlan 0/X>
Description
Index of the SSID list
Keyword for a security context
Enter a valid security context ID.
.
wlan security context
show wlan ssid-table
Range of values / note
1...8
-
Available only in client mode
1...8
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.