No Wlan Dfs Multi-Radar-Detection; Wlan Dtim (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.5.38

no wlan dfs multi-radar-detection

Description
With this command you disable access points exchanging information about radar signals
among themselves and verifying them.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs multi-radar-detection
Result
The function is disabled.
Further notes
You display the setting with the
You enable the function with the
6.1.5.39

wlan dtim (access point)

Description
With this command, you configure the DTIM interval. The DTIM interval (1-15) specifies the
number of beacons to be sent before the access point sends the packets
(broadcast/unicast/multicast) to the client.
If, for example, you enter "5", this would mean that the access point collects the packets and
sends them after every fifth beacon.
Note
This command is available only in access point mode.
190
show wlan advanced <wlan 0/X>
wlan dfs multi-radar-detection
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.