Sender Mail-Address; No Sender Mail-Address - Siemens SIMATIC NET Configuration Manual

7.5.2.3

sender mail-address

Description
With this command, you configure the e-mail name of the sender.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
sender mail-address <mail-address>
The parameter has the following meaning:
Parameter
mail-address
Result
The e-mail name of the sender is configured.
Further notes
You reset the e-mail name of the sender with the
You display the setting with the
7.5.2.4

no sender mail-address

Description
With this command, you reset the e-mail name of the sender.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Email name of the sender
show events sender email
Range of values / note
max. 100 characters
no sender mail-address
command.
Network protocols
7.5 SMTP client
.
357