Commands In The Dhcppool Configuration Mode; Lease-Time - Siemens SIMATIC NET Configuration Manual

Network protocols
7.3 DHCP server
7.3.3

Commands in the DHCPPOOL configuration mode

This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
mode.
● If you exit the DHCPPOOL Configuration mode with the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
Privileged EXEC mode.
7.3.3.1

lease-time

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
With this command, you specify how long the assigned IPv4 address remains valid. Once
this period has elapsed, the device must either request a new IPv4 address or extend the
lease time of the existing IPv4 address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
lease-time <seconds (60-31536000)>
The parameter has the following meaning:
Parameter
seconds
312
ip dhcp-server pool
Description
Time until renewal of the assigned
IPv4 address in seconds
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command to change to this
command, you return to the
exit
command, you return to the
end
Range of values / note
60 ... 31536000
Configuration Manual, 10/2015, C79000-G8976-C351-05