Show Spanning-Tree Mst Interface - Siemens SIMATIC NET Configuration Manual

6.3.1.8

show spanning-tree mst interface

Description
This command shows port-specific settings of a Multiple Spanning Tree configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst
[<instance-id(1-64)>] interface<interface-type><interface-id>
[{stats|hello-time|detail}]
The parameters have the following meaning:
Parameter
instance-id
interface-
type
interface-id
stats
hello-time
detail
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description
Number of the instance or range of instances
whose settings are displayed
Type or speed of the interface
Module no. and port no. of the interface
Shows the number of incoming and outgoing
packets for each path of the interface
Shows the intervals at which the root switch
sends its "Hello" message to the other
switches
Shows detailed information about the select-
ed interface
Network structures
6.3 Spanning Tree
Range of values / note
1 ... 64
Enter a valid interface.
-
-
-
show spanning-tree
247