Commands In The Events Configuration Mode; Syslogserver - Siemens SIMATIC NET Configuration Manual

Diagnostics
11.2 Syslog client
11.2.2

Commands in the Events configuration mode

This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
11.2.2.1

syslogserver

Description
With this command, you configure the Syslog server address.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Syntax
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr> | fqdn-name <FQDN>} [<port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
port
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for the Syslog server are configured.
454
events
Description
Keyword for an IP address
Syslog server IPv4 Address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Serverport
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
1 .. 65535
Default: 514
Configuration Manual, 10/2015, C79000-G8976-C351-05