Description; Working With The Command Line Interface (Cli) - Siemens SIMATIC NET Configuration Manual

Description

Note
Interruption of the WLAN communication
The WLAN communication can be influenced by high frequency interference signals and can
be totally interrupted.
Remember this and take suitable action.
2.1

Working with the Command Line Interface (CLI)

Introduction
All the configuration settings for the device can be made using the Command Line Interface
(CLI). The CLI therefore provides the same options as Web Based Management (WBM).
You should read the detailed explanations of the parameters in the relevant configuration
manual "Web Based Management". The CLI allows remote configuration over Telnet.
Note
Use with Windows 7
If you want to access the Command Line Interface in Windows 7, make sure that the
functions required for this are enabled in Windows 7.
Starting the CLI in a Windows console
Follow the steps outlined below to start the Command Line Interface in a Windows console:
1. Open a Windows console and type in the command "telnet" followed by the IP address of
the device you are configuring:
C:\>telnet <IP address>
2. Enter your login and password.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
2
19