Snmp Agent Version - Siemens SIMATIC NET Configuration Manual

Network protocols
7.4 SNMP
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmpagent
Result
The SNMP agent function is disabled.
Further notes
You enable the SNMP agent function with the
7.4.2.3

snmp agent version

Description
With this command, you configure whether all SNMP queries or only SNMPv3 queries are
processed.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp agent version{v3only|all}
The parameters have the following meaning:
Parameter
v3only
all
Result
The setting is configured.
332
snmpagent
Description
only SNMPv3 queries are processed
all SNMP queries are processed
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
Range of values / note
-
Default: all
Configuration Manual, 10/2015, C79000-G8976-C351-05