No Lldp - Siemens SIMATIC NET Configuration Manual

The parameters have the following meaning:
Parameters
transmit
receive
At system start or when using the
following defaults apply:
● Sending and receipt of LLDP packets are enabled.
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Result
The setting is configured.
Further notes
You disable the sending or receipt of LLDP packets with the
You display the status of LLDP with the
3.1.10.6

no lldp

Description
With this command, you disable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no lldp{transmit|receive}
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
the sending of LLDP packets is enabled
the receipt of LLDP packets is enabled
command with the option
restart
show lldp status
Configuration
or
memory factory
command.
no lldp
command.
3.1 System
, the
63