Samsung OfficeServ 7100 Technical Manual page 452

OfficeServ 7100
TECHNICAL MANUAL
Option
EASYSET OPTION
CTI LINK OPTION
ITP DSP PARA
MMC: 841
Description
1 PSWD: This is the system-wide password for ITP phones to
register with then the TYPE setting above is set to
SYS PSWD.
Sets EasySet link via LAN option with the system.
0 PSWD: This is the password EasySet will use to establish a
connection to the OfficeServ 7100
1 ALIVE TIME: Determines the time between keep-alive
messages to EasySet
0 SMDR REPORT: Determines whether or not SMDR data will be
sent over the CTI link
1 UCD REPORT: Determines whether or not UCD report data will
be sent over the CTI link
2 ALIVE TIME: Determines the time between keep-alive
messages to the CTI server
0 M-FRAME: This value determines the transmission interval
time of VoIP packets generated by the IP phone. The range is
10~40 ms. Applies only to ITP to ITP calls (when both ITPs
are on the same subnet).
1 JITTER: Decides the minimum time to consider delay for
jitter adjustment. The range is 10~90 ms. Applies only to
ITP to ITP calls (when both ITPs are on the same subnet).
2 TOS/Dif: An eight-bit binary value that will be utilized by
external routers, switches, etc(that optionally support TOS-
bit prioritization)-to identify the transport-priority value of
data packets generated by the IP phone. This value can
be left at default value(00000) if your network infrastructure
does not support this method of bandwidth management.
Applies only to ITP to ITP calls (when both ITPs are on the
same subnet).
3 CONTROL
1 SYS BASE
2 ITP BASE
4 CODEC
1 MGI FIRST – Use the default MGI codec
2 ITP FIRST – Use the codec specified for the ITP phone in
MMC 840
Table of Contents
Home Page
PROGRAMMING
PART 2 MAY 2009
Default
'1234'
-
'1234'
0 SEC
NO
NO
300 SEC
10 ms
20 ms
all bits 0
SYS BASE
MGI FIRST