Samsung OfficeServ 7100 Technical Manual page 184

OfficeServ 7100
TECHNICAL MANUAL
MMC: 430
DESCRIPTION:
This MMC allows the technician to program a TEPRI or TEPRIa trunk card, which
has been designated as a PRI. The normal mode of operation for a PRI facility in
the US is DID (i.e., shown as DDI in this MMC) service for incoming calls and
senderized operation (i.e., the switch provides dial tone, collects the called number
digits, and then places the call) for outgoing calls. The only useful mode of
operation for a U.S. PRI is the DDI (i.e., DID) mode. Further, the default Timer
settings are appropriate for the U.S. and should not be changed unless you are
instructed to do so by the Samsung Product and/or Technical Support
Departments.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
HOLD
OPTION TABLE
ANY CHANNEL:
YES = Preferred channel selection (i.e., another idle channel may be used for this
call if this channel is initially selected);
NO = Exclusive channel selection (i.e., only this channel may be used)
for this call if this channel is initially selected)
PRI MODE: DDI = the only valid U.S. selection (U.S. DID mode); NORMAL = don't
use in the U.S.A.
CH. SELECT:
HIGH = hunt for a channel from the highest numbered channel to the lowest when
making an outgoing call;
LOW = hunt for a channel from the lowest numbered channel to the highest when
making an outgoing call
SWH:
The ISDN protocol you wish to run (e.g., NI_2, 5ESS10, DMS100, NI_1, Bellcore
5ESS5, 5ESS9)
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Home Page
PROGRAMMING
PART 2 APRIL 2007
PRI CONTROL
Table of Contents