Turf Guardian Tm Leak Detector Alarm (If Equipped) - Toro Greensmaster TriFlex 3320/3420 Service Manual

TM
Turf Guardian Leak Detector Alarm (If Equipped)
NOTE: The Turf Guardian
optional on Greensmaster TriFlex Hybrid machines.
Machines equipped with the Turf Guardian
tector System include an alarm that sounds if a hydraulic
leak is detected by the system. The alarm is attached to
the outside of the control console assembly.
Testing
1. Park machine on level surface, lower cutting units,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove console cover from console assembly to
gain access to alarm (see Control Console Disassembly
in the Service and Repairs section of Chapter 7 -- Chas-
sis).
IMPORTANT: Make sure to observe polarity on the
alarm terminals when testing. Damage to the alarm
may result from an improper connection.
3. Disconnect wire harness connector from alarm. Cor-
rectly connect 12VDC source to the alarm terminals
(Fig. 94). Alarm should sound.
4. Remove voltage source from the alarm. Replace
alarm if necessary. Connect wire harness connector to
alarm.
5. Install console cover (see Control Console Assem-
bly in the Service and Repairs section of Chapter 7 --
Chassis).
Electrical System
TM
Leak Detector System is
TM
Leak De-
1
1. Top view
2. Bottom view
Page 6 - - 72
3
Figure 94
3. Positive (+) terminal
4. Negative (- -) terminal
Greensmaster 3320/3420
4
2