Cutting Unit Suspension Assembly - Toro Greensmaster TriFlex 3320/3420 Service Manual

Cutting Unit Suspension Assembly

85 to 115 in- -lb
(9.6 to 12.9 N- -m)
16
21
RIGHT
FRONT
1. Suspension assembly (3 used)
2. Flange screw (3 per suspension)
3. Basket
4. Clevis pin (3 used)
5. Cotter pin (3 used)
6. Washer (3 used)
7. LH spring retainer (3 used)
NOTE: Three (3) identical cutting unit suspension as-
semblies are used on Greensmaster TriFlex Hybrid ma-
chines. The cutting unit attaches to the crossarm
assembly which is attached to the front of the cutting unit
suspension assembly. The crossarm assembly can be
serviced with the suspension assembly attached to the
machine (see Cutting Unit Suspension Crossarm As-
sembly in this section).
Chassis
19
18
19
20
5
9
15
Figure 19
8. Lift cylinder
9. RH stabilizer spring (3 used)
10. LH stabilizer spring (3 used)
11. Spacer (6 used)
12. Cap screw (6 used)
13. Flange nut (6 used)
14. Flange head screw (6 used)
Page 7 - - 22
16
17
6
7
1
12
3
15. RH spring retainer (3 used)
16. Socket head screw (6 used)
17. Cable bracket
18. Cable bracket
19. Washer head screw (4 used)
20. Cable bracket
21. Cable bracket (2 used)
Removal (Fig. 19)
1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
85 to 115 in- -lb
(9.6 to 12.9 N- -m)
8
14
11
4
13
55 to 60 ft- -lb
(75 to 81 N- -m)
10
Greensmaster 3320/3420
2