Adjustments; Adjustments; Parking Brake Adjustment - Toro Greensmaster TriFlex 3320/3420 Service Manual

Adjustments

Parking Brake Adjustment

1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. With parking brake engaged, measure the distance
between the centers of the two (2) pins that secure the
brake spring to the brake lever and the equalizer brack-
et. This distance should be from 6.120" to 6.240" (156
to 158 mm) (Fig. 4).
3. If necessary, adjust location of brake cable jam nuts
at brake cable bracket so that distance between pins is
correct.
4. After adjusting parking brake cables, check that
brake actuator levers are fully released when parking
brake is not applied. Also, when parking brake is not ap-
plied, front wheels should rotate freely.
Greensmaster 3320/3420
1
6.120" to 6.240"
(156 to 158 mm)
1. Brake lever (engaged)
2. Lever pin
1. Brake cable (RH shown)
2. Jam nuts
3. E- -ring
Page 7 - - 5
2
4
3
Figure 4
3. Equalizer pin
4. Brake spring
1
2
4
3
5
Figure 5
4. Clevis pin
5. Brake assembly
Chassis