Initiating A Conference - Huawei V100R001 User Manual

HUAWEI TE30 Videoconferencing Endpoint
User Guide
Parameter
Dynamic
bandwidth
reserved
presentation
bandwidth
Preferred IP
protocol
Step 2 Select Save.
----End

6.3 Initiating a Conference

Your TE30 provides multiple paths to initiating a conference.
Your TE30 displays the conferencing screen after its startup. You can also access the
conferencing screen using either of the following methods:


From the Call Screen
Perform any of the following:
Issue 01 (2013-03-27)
Description
parameter to Limited for better
video conference quality.
Specifies whether the TE30
implements the following if the
packet loss rate increases due to
insufficient network bandwidth:
automatically decreases the
conference bandwidth until packet
loss does not occur constantly or
the conference bandwidth is
decreased to 64 kbit/s. If constant
packet loss is detected, the TE30
can dynamically adjust bandwidth
to recover stable conference
quality within 1 minute.
Specifies whether to reserve
bandwidth for presentations when
no presentation is being shared.
When this function is enabled,
your TE30 reserves bandwidth for
presentation sharing, instead of
using all of the bandwidth for
video transmission.
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for
IP sites, your TE30 uses this
protocol to call the IP sites.
Press on the remote control.
Select from the option bar.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Conference
Setting
This parameter is deselected by
default.

When the network is running
within normal parameters, do
not select this parameter.

When the network is not
running within normal
parameters, do not select this
parameter.
The default value is Enable.
The default value is H.323.
45