Accessories And Spares - GE MDS SD Series Reference Manual

6 SD Series Ref. Manual (Packet & Transparent Mode)

2.5 Accessories and Spares

Table 1 lists common accessories and spare items for the transceiver.
GE MDS also offers an Accessories Selection Guide listing an array of
additional items that may be used with the product. Contact your factory
representative or visit
Table 1. Accessories & Spare Items
Accessory
DC Power Plug,
2-pin, polarized
Retrofit Kit, Digital
Retrofit Kit, Analog
Instruction Sheet
(for Packet and
Transparent Modes)
Flat Mounting
Brackets
(Standard)
Flat Mounting
Brackets
(x710-compatible)
DIN Rail Mounting
Bracket Kit
Reprogramming
Application for
Firmware Upgrade
to obtain a copy of the guide.
www.gemds.com
Description
Mates with power connector on radio
case. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect.
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
digital transceiver.
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
analog transceiver.
Describes the installation and setup
of the transceiver. A companion to
this Reference Manual.
Brackets that attach to the bottom of
the unit. Used for mounting to a flat
mounting service.
Brackets that attach to the bottom of
the unit. Used for mounting to a flat
mounting service. Bracket matches
MDS x710 Transceiver mounting
holes.
Contains bracket for mounting the
transceiver to standard 35 mm DIN
rails commonly used in equipment
cabinets and panels.
Automated software program for
upgrading the radio's internal
firmware code. This application is
under development at press time.
Check with your factory
representative for availability.
Part Number
73-1194A53
03-4696A01
03-4697A01
05-4847A01
03-4123A14
Consult
Factory
03-4125A04
06-6241A01
MDS 05-4846A01, Rev. C