GE MDS SD Series Reference Manual page 109

MDS 05-4846A01, Rev. C
Figure 81. TFTP Server Screen
3. Verify the radio's IP address by navigating to the IP Menu (
Menu>>Ethernet Configuration>>IP
appears.
Figure 82. IP Configuration Menu
4. Set the IP Address, Netmask, and Default Gateway as appropriate.
Note the default gateway must be on the same subnet as the trans-
ceiver. Alternately, if a DHCP server is available, enable DHCP and
wait several seconds for the IP setting to be obtained from the
server. The IP settings used are shown at the bottom of the screen.
5. Ping radio's IP address from the PC using a Ping Utility. Verify that
the radio responds.
6. Access the Local Reprogram Menu (Figure 83).
(
Main Menu>>Maintenance/Tools>>Local Reprogram Menu
SD Series Ref. Manual (Packet & Transparent Mode)
Invisible place holder
(GE MDS Server shown)
). The menu shown in Figure 82
Invisible place holder
Main
)
101