Serial Configuration - GE MDS SD Series Reference Manual

TCP Keepalive Time
Restoring
Configuration
Committing
Configuration
Settings
MDS 05-4846A01, Rev. C
2. Enter the desired port number, followed by
change. Port numbers below 2000 should be avoided, as some are
reserved for special applications in data networks.
This setting specifies the number of seconds that the TCP socket is
active after the receipt of data. To set the time, proceed as follows:
1. Select
TCP Keepalive
clears and a flashing cursor appears.
2. Enter the number of seconds for the TCP socket to remain active
after the receipt of data, followed by
In some cases, you may wish to revert to the previous configuration of
the menu, prior to any changes being committed. This might be useful if
one or more settings were inadvertently changed and you wish to return
to a known menu state. To restore the menu settings, simply select
. The message
Restore Configuration
bottom of the screen to confirm the action.
Once you are satisfied with all of the settings on the menu, you make
them active by selecting
appears at the bottom of the screen to confirm the
Changes committed
action.

6.11 Serial Configuration

This section explains the settings for the
the transceiver. These settings are accessed from the Serial Configura-
tion Menu (Figure 55).
Figure 55. Serial Configuration Menu
SD Series Ref. Manual (Packet & Transparent Mode)
on the menu. The field to the right of the item
ENTER
Configuration restored
on the menu. The message
Commit Configuration
COM1
Invisible place holder
to apply the
ENTER
to apply the setting.
appears at the
and serial ports of
COM2
71