GE MDS SD Series Reference Manual page 108

Upgrade Procedure
100 SD Series Ref. Manual (Packet & Transparent Mode)
REMOTE PC
W/FIRMWARE FILE
TFTP
SERVER
ETHERNET
PORT
IP ADDRESS: w.x.y.z
LOCAL WINDOWS PC
COM1, 2, ETC.
(DTE)
Figure 80. Firmware Upgrade Setup—Option 2
(TFTP Server & Firmware File Reside on Remote Server;
Requires a private/quiet Ethernet LAN.)
NOTE: The flow of payload data is maintained during TFTP repro-
gramming.
To load a new firmware file (
following procedure:
1. Connect an Ethernet cable between the radio's
(refer to Figure 79 or Figure 80, as applicable).
2. Launch the TFTP server and click the
below) and modify the
to the folder where the reprogramming package (
located. The path (C) will be displayed once the operation is com-
pleted. Leave the application running until reprogramming on the
radio is complete.
Invisible place holder
HUB/LAN/WAN/MAN
TCP/IP
TO LAN
PORT
PORT (DCE)
E
-
INITIATE UPLOAD
FROM HERE
) into the transceiver, use the
filename.mpk
Options
(B) using your browser to point
Outgoing path
MDS 05-4846A01, Rev. C
TRANSCEIVER
TO COM1
port and the PC
LAN
tab (A in Figure 81
file) is
.mpk