GE MDS SD Series Reference Manual page 31

MDS 05-4846A01, Rev. C
PC Running Terminal Session
Figure 20. PC Connection to Transceiver
3.
Press the key followed by a series of
ESCAPE
half-second intervals) to receive the
the radio is ready to receive commands. (If a "
seen, the radio is set to command line mode. Enter
command line.)
4. At the prompt, enter
Login:
NOTE:
Passwords are case sensitive and may use up to 13 alpha-numeric charac-
ters. Do not use punctuation mark characters.
5. If no password has been previously set, enter the default password
( ) and press
admin
the prompt. (Before placing the unit in final service, it is
Password:
recommended that the default password be changed using the Secu-
rity Configuration Menu.)
6. After successful login, the Starting Information Screen appears
(Figure 21), showing summary information about the radio. This
screen is read-only, but some of the fields change based on user-sup-
plied data at other menu screens.
NOTE:
TX and RX frequencies may not be set when the radio is shipped from the
factory, depending on ordering options. If frequencies have not been set,
Major Alarms Present
Screen and the PWR led will flash. These will be cleared after the frequen-
cies are set. In all cases, users should verify that the frequencies are prop-
erly set according to the station license.
SD Series Ref. Manual (Packet & Transparent Mode)
Invisible place holder
prompt
Login:
(lower case) and press
admin
; Otherwise, enter the saved password at
ENTER
will be displayed on the Starting Information
Transceiver
DB-9M to COM1 Port
key presses (at
ENTER
. This indicates that
" or " " symbol is
> >>
to leave
Menu
ENTER
.
23