GE MDS SD Series Reference Manual page 117

From Menu Mode
to...
From Diagnostic
Mode to Menu Mode
From Data Mode to...
From Command
Line Mode to...
MDS 05-4846A01, Rev. C
• Menu to Command line—Press
Information Screen).
• Menu to Diagnostic Mode—In the Diagnostic Settings Menu,
make sure DLINK is enabled. In the COM1 Port Settings Menu,
make sure startup mode is set to
10 minute inactivity timeout.
• Menu to Data Mode—In COM1 Port Settings Menu, switch cur-
rent mode to .
DATA
• Menu to Data Mode (on bootup)—In COM1 Port Settings
Menu, make sure startup mode is set to
allow 10 minute inactivity timeout.
• Menu to x710 Command Line—Press the Escape key at the
Starting Information Screen and
• Diagnostic Mode (DLINK) to Menu—Autobaud: (Press carriage
return at 1/2 second intervals 2-10 times at supported user inter-
face baud rate, 8N1 data parameters)
• Data Mode to Menu—Enter
and format. Switch to supported user interface baud rate and 8N1
parameters as necessary, and autobaud as described above.
• Data Mode to Menu (on bootup)—Autobaud as described above
during the first 10 seconds of bootup.
• Command line to Menu—Enter
• x710 Command Line to Menu—This requires switching operat-
ing mode to packet or transparent mode (requires authorization).
Enter and then
menu
Figure 86. COM1 Port Settings Menu
SD Series Ref. Manual (Packet & Transparent Mode)
at any menu (except Starting
X
. Press
Console
DATA
at confirmation prompt.
Y
at configured
+++
at the command prompt.
Menu
at the confirmation prompt.
Y
Invisible place holder
, reboot or allow
Q
. Press , reboot, or
Q
baud rate
COM1
109