Accessories And Spares - GE MDS SD Series Technical Manual

IMPORTANT: This manual does not cover x710 Mode operation. Refer instead to the follow-
ing manuals for x710 instructions:
•
Start-Up Guide (x710 Mode) — Part No. 05-4669A01
•
Technical Manual (x710 Mode) — Part No. 05-4670A01
Figure 3. SD Transceivers offer compatibility with older MDS x710 Transceivers (left), and
may be used for replacement and/or interoperability in these networks.
A retrofit kit is available for connector conversion (see Accessories & Spare Items).

2.5 Accessories and Spares

Table 1 lists common accessories and spare items for the transceiver. GE MDS also offers an
Accessories Selection Guide listing additional items that may be used with the product. Visit
or contact your factory representative to obtain a copy of the guide.
www.gemds.com
Accessory
Retrofit Kit, Digital
Retrofit Kit, Analog
DC Power Plug, 2-
pin, polarized
Setup Guide
(for Packet and
Transparent Modes)
Flat Mounting
Bracket Kit
DIN Rail Mounting
Bracket Kit
MDS 05-4864A01, Rev. I
Table 1. Accessories & Spare Items
Description
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M digital
transceiver.
Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS x710A/C/M
analog transceiver.
Mates with power connector on radio
case. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect.
Describes the installation and setup
of the transceiver. A companion to
this Technical Manual.
Brackets that attach to the bottom of
the unit. Used for mounting to a flat
mounting surface. Fits the mounting
footprint of MDS x710 transceivers.
Contains bracket for mounting the
transceiver to standard 35 mm DIN
rails commonly used in equipment
cabinets and panels.
SD Series Technical Manual
Part Number
03-4696A01
03-4697A01
73-1194A53
05-4847A01
03-4123A14
03-4125A04
7