Blomberg WM 77110 NBL00 Owner's Manual page 33

There is water coming
from the bottom of the
washer.
Washer fills with water
when a process is
cancelled.
Time delay function does
not work.
The door will not open.
The door will not lock/
door expression is on
LCD
Inlet hose connections may be
leaking.
End of the drain hose may be
loosely inserted into the waste
pipe or sink.
House drain may be clogged.
Filter cap of the drain pump may
not be properly fitted.
Hose connections inside the
washer may be leaking.
There may be hot water inside
washer.
Door may not be closed properly.
Water level might be above the
lower level of the door.
Washer might be heating up the
water or it may be at the spinning
cycle.
Due to electrical safety
mechanism, the door can only be
opened a few minutes after the
program has stopped.
If the door can not be opened
after minimum ten minutes the
program has stopped , on/off
buton should be placed to off
position.
Door is not properly closed/Door
hinge is not aligned with lock
switch.
33
Be sure the strainers and rubber
seals of the water inlet hoses are
solid and securely fitted.
Tightly attach the drain hose to the
waste pipe or sink (See "Installation
Instructions, Drainage").
If the house drain pipes are clogged,
call a plumber for assistance.
Make sure that the pump filter cap is
tightly closed.
Internal hose connections (e.g.
dispenser hoses, drain system)
should be checked by a service
technician.
For safety reasons, water should be
cycled in and out a couple times.
Close the loading door.
Run "Drain" , "Spin" or "Drain&Spin"
program.
Wait until the process is over.
Wait until the process is over.
In this situation, call the qualified
service technician.
Push the loading door firmly shut
until you hear it lock into space
EN