Configure Metric Values
The following topics are covered in this section:
•
Maximum Values in the Routing Table on page 532
•
Changing the IS-IS Metric Style in One Level Only on page 532
•
Leaking from One Level to Another on page 534
For any level (Level-1, Level-2, or Level-1-2), the value range possible in the
INTERFACE mode changes depending on the metric style.
Table 23-4. Correct Value Range for the isis metric Command
Metric Style
wide
narrow
wide transition
narrow transition
transition
Maximum Values in the Routing Table
IS-IS metric styles support different cost ranges for the route. The cost range for the narrow metric style is
0 to 1023, while all other metric styles support a range of 0 to 0xFE000000.
Changing the IS-IS Metric Style in One Level Only
By default, the IS-IS metric style is narrow. When you change from one IS-IS metric style to another, the
IS-IS metric value (configured with the
In the following scenarios, the IS-type is either Level-1 or Level-2 or Level-1-2 and the metric style
changes.
Table 23-5. Metric Value when Metric Style Changes
Beginning metric style
wide
wide
532
|
Intermediate System to Intermediate System
Correct Value Range for the isis metric Command
0 to 16777215
0 to 63
0 to 16777215
0 to 63
0 to 63
isis metric
command) could be affected.
Final metric style
narrow
transition
isis metric
Resulting IS-IS metric value
default value (10) if the original value is greater than
63.
A message is sent to the console.
truncated value
1
(the truncated value appears in the
LSP only.)
The original isis metric value is displayed in the
show config and show running-config
commands and is used if you change back to
transition metric style.
command in