show configuration
The
you to display the running configuration only for interfaces that are part of interface range.
Bulk Configuration Examples
The following are examples of using the
•
Create a single-range
•
Create a multiple-range
•
Exclude duplicate entries
•
Exclude a smaller port range
•
Overlap port ranges
•
Commas
•
Add ranges
Create a single-range
Figure 20-20. Creating a Single-Range Bulk Configuration
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range-gi-5/1-23)# no shutdown
Create a multiple-range
Figure 20-21. Creating a Multiple-Range Prompt
FTOS(conf)#interface range tengigabitethernet 3/0 , gigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-gi-2/1-47,so-5/0)#
Exclude duplicate entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt:
Figure 20-22. Interface Range Prompt Excluding Duplicate Entries
FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
FTOS(conf-if-range-vl-1,vl-3)#
FTOS(conf)#interface range gigabitethernet 2/0 - 23 , gigabitethernet 2/0 - 23 , gigab 2/0 - 23
FTOS(conf-if-range-gi-2/0-23)#
Exclude a smaller port range
If interface range has multiple port ranges, the smaller port range is excluded from prompt:
command is also available under the interface range mode. This command allows
interface range
command for bulk configuration:
Interfaces | 441