Encrypt Ftsa Messages - Dell Force10 C150 Configuration Manual

To add a recipient, you first create a mnemonic label for it. FTOS uses this label to create an FTOS context
in which you can configure the E-mail parameters for the recipient. For example, the default recipient is
Dell Force10 TAC and the label for this recipient is Force10. FTOS creates the context
conf-callhome-Force10 in which you can configure the parameters for E-mails destined for Dell Force10
TAC only, as shown in
Figure 16-2. Displaying the Default FTSA E-mail Recipient Configuration
FTOS(conf-callhome)#show config
!
call-home
no enable-all
server Force10
recipient
keyadd Force10DefaultPublicKey
encrypt
no enable
FTOS(conf-callhome-Force10)#?
enable
encrypt
end
exit
keyadd
log-messages
no
recipient
show
FTOS(conf-callhome-Force10)#show config
server Force10
recipient
keyadd Force10DefaultPublicKey
encrypt
no enable
To add a recipient:
Step Task
1 Create a mnemonic label for the recipient.
2 Enter the recipient E-mail address in the form
username

Encrypt FTSA Messages

Encrypting FTSA message to a recipient other than the default is supported only on platforms:
352 | Force10 Service Agent
Figure 16-2.
ftsa@force10networks.com
Enable call-home service for this server
Encrypt emails for this server
Exit from configure mode
Exit from call-home server mode
Add server's public key for encryption
Add log information
Reset a command
Enter server email
Show call-home server configuration
ftsa@force10networks.com
@domain-name.com.
Command
server
label
recipient
email-address
Command Mode
CONFIGURATION
CONFIGURATION
c e