Dell Force10 C150 Configuration Manual page 930

To specify multiple RADIUS server hosts, configure the
multiple RADIUS server hosts are configured, FTOS attempts to connect with them in the order in which
they were configured. When FTOS attempts to authenticate a user, the software connects with the
RADIUS server hosts one at a time, until a RADIUS server host responds with an accept or reject
response.
If you want to change an optional parameter setting for a specific host, use the
command. To change the global communication settings to all RADIUS server hosts, refer to
communication parameters for all RADIUS server hosts on page
To view the RADIUS configuration, use the
mode.
To delete a RADIUS server host, use the
Set global communication parameters for all RADIUS server hosts
You can configure global communication parameters (auth-port, key, retransmit, and timeout parameters)
and specific host communication parameters on the same system. However, if both global and specific host
parameters are configured, the specific host parameters override the global parameters for that RADIUS
server host.
To set global communication parameters for all RADIUS server hosts, use any or all of the following
commands in the CONFIGURATION mode:
Command Syntax
radius-server deadtime seconds
radius-server key
radius-server retransmit retries
radius-server timeout seconds
930 | Security
[ encryption-type ] key
radius-server host
show running-config radius
no radius-server host
Command Mode Purpose
CONFIGURATION Set a time interval after which a RADIUS host
server is declared dead.
•
CONFIGURATION Configure a key for all RADIUS communications
between the system and RADIUS server hosts.
•
•
CONFIGURATION Configure the number of times FTOS retransmits
RADIUS requests.
•
CONFIGURATION Configure the time interval the system waits for a
RADIUS server host response.
•
command multiple times. If
radius-server host
930.
command in the EXEC Privilege
{ | } command.
hostname ip-address
range: 0 to 2147483647.
seconds
Default: 0 seconds
encryption-type: Enter 7 to encrypt the
password. Enter 0 to keep the password as plain
text.
key: Enter a string. The key can be up to 42
characters long. You cannot use spaces in the
key.
retries range: 0 to 100. Default is 3 retries.
range: 0 to 1000.
seconds
Default is 5 seconds.
Set global