Dell Force10 C150 Configuration Manual page 686

Figure 31-5. Command Example:
FTOS(conf)#track 104 ip route 10.0.0.0/8 reachability
FTOS(conf-track-104)#delay up 20 down 10
FTOS(conf-track-104)#end
FTOS#show track 104
Track 104
IP route 10.0.0.0/8 reachability
Reachability is Down (route not in route table)
2 changes, last change 00:02:49
Tracked by:
FTOS#configure
FTOS(conf)#track 4 ip route 3.1.1.0/24 reachability vrf vrf1
Figure 31-6. Command Example:
FTOS(conf)#track 105 ipv6 route 1234::/64 reachability
FTOS(conf-track-105)#delay down 5
FTOS(conf-track-105)#description Headquarters
FTOS(conf-track-105)#end
FTOS#show track 105
Track 105
IPv6 route 1234::/64 reachability
Description: Headquarters
Reachability is Down (route not in route table)
2 changes, last change 00:03:03
Tracked by:
Tracking a Metric Threshold
To configure object tracking on the metric threshold of an IPv4 or IPv6 route, use the following
commands. To remove object tracking, enter the
Step Task
1 (Optional) Reconfigure the
default resolution value used by
the specified protocol to scale the
metric for IPv4 or IPv6 routes.
2 Configure object tracking on the
metric of an IPv4 or IPv6 route.
686 | Object Tracking
track ip route reachability
track ipv6 route reachability
no track object-id
Command Syntax
track resolution ip route |
{
{isis resolution-value | ospf resolution-value}
Range of resolution values:
ISIS routes - 1 to 1000. Default: 1.
OSPF routes - 1 to 1592. Default: 1.
track
object-id
ip route ip-address/prefix-len
{
ipv6 route ipv6-address/prefix-len
[ vrf
metric threshold
vrf-name
Valid object IDs are from 1 to 65535.
Enter an IPv4 address in dotted decimal format.Valid
IPv4 prefix lengths are from /0 to /32.
Enter an IPv6 address in X:X:X:X::X format. Valid
IPv6 prefix lengths are from /0 to /128.
(Optional) E-Series only: For an IPv4 route, you can
enter a VRF name.
command.
Command Mode
ipv6 route}
CONFIGURATION
CONFIGURATION
|
}
]