Configuration Information - Dell Force10 C150 Configuration Manual

Table 23-1
Table 23-1.
IS-IS Parameter
Complete Sequence Number PDU (CSNP) interval
IS-to-IS hello PDU interval
IS-IS interface metric
Metric style
Designated Router priority
Circuit Type
IS Type
Equal Cost Multi Paths

Configuration Information

To use IS-IS, you must configure and enable IS-IS in two or three modes: CONFIGURATION ROUTER
ISIS, CONFIGURATION INTERFACE, and ( when configuring for IPv6) ADDRESS-FAMILY mode.
Commands in ROUTER ISIS mode configure IS-IS globally, while commands executed in INTERFACE
mode enable and configure IS-IS features on that interface only. Commands in the ADDRESS-FAMILY
mode are specific to IPv6.
Note that by using the IS-IS routing protocol to exchange IPv6 routing information and to determine
destination reachability, you can route IPv6 along with IPv4 while using a single intra-domain routing
protocol. The configuration commands allow you to enable and disable IPv6 routing and to configure or
remove IPv6 prefixes on links.
Except where identified, the commands discussed in this chapter apply to both IPv4 and IPv6 versions of
IS-IS.
512 | Intermediate System to Intermediate System
displays the default values for IS-IS.
IS-IS Default Values
Default Value
10 seconds
10 seconds
10
Narrow
64
Level 1 and Level 2
Level 1 and Level 2
16