Displaying Information On A Management Interface - Dell Force10 C150 Configuration Manual

Displaying Information on a Management Interface

To view information about the primary RPM management port, use the
Managementethernet
command in EXEC or EXEC Privilege mode. If there are two RPMs on the system,
you cannot view information on the interface.
Figure 20-9. Command Example:
FTOS>show interface managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:5d:b7:4c
Current address is 00:01:e8:5d:b7:4c
Pluggable media not present
Interface index is 503595208
Internet address is 10.11.197.97/16
Link local IPv6 address: fe80::201:e8ff:fe5d:b74c/64
Global IPv6 address: fdaa:bbbb:cccc:1004::50/64
Virtual-IP address is 10.11.197.99/16
Virtual-IP IPv6 address is fdaa:bbbb:cccc:1004::60/64
FTOS# show running-config interface managementethernet 0/0
interface ManagementEthernet 0/0
ip address 10.11.197.97/16
ipv6 address fdaa:bbbb:cccc:1004::50/64
!virtual-ip 10.11.197.99/16
!virtual-ip fdaa:bbbb:cccc:1004::60/64
no shutdown
To view summary information about the primary RPM Management port, use the
Managementethernet
or
Privilege mode.
Figure 20-10. Command Example:
FTOS>show ip interface brief managementethernet 0/0
Interface
ManagementEthernet 0/0
Figure 20-11. Command Example:
FTOS#show ipv6 interface brief managementethernet 0/0
ManagementEthernet 0/0
fe80::201:e8ff:fe5d:b74c
fdaa:bbbb:cccc:1004::50/64
show interface ManagementEthernet
show ipv6 interface brief Managementethernet
show ip interface brief ManagementEthernet
IP-Address OK
10.11.197.97 YES Manual up
show ipv6 interface brief ManagementEthernet
[up/up]
show interface
Method Status
show ip interface brief
commands in EXEC or EXEC
Protocol
up
Interfaces | 425