When To Use Cam Profiling - Dell Force10 C150 Configuration Manual

Message 2 EH Line Card with EG Chassis Profile Error
# Before reload:
01:09:56: %RPM0-P:CP %CHMGR-4-EH_PROFILE_WARN: If EH CAM profile is selected, non-EJ cards
will be in problem state after reload
# After reload:
00:04:46: %RPM0-P:CP %CHMGR-3-PROFILE_MISMATCH: Mismatch: line card 1 has mismatch CAM
profile or microcode
Figure 11-1. EF Line Card with EG Chassis Profile—Card Problem
R1#show linecard 1 brief
-- Line card 1 --
Status
Next Boot
Required Type : E48TF - 48-port 10/100/1000Base-T line card with RJ-45 interfaces (EF)
Current Type
Hardware Rev
Num Ports
Up Time
FTOS Version
Jumbo Capable : yes
Figure 11-2. EH Line Card with EG Chassis Profile—Card Problem
R1#show linecard 1 brief
-- Line card 1 --
Status
Next Boot
Required Type : E90MH - 90-port 10/100/1000Base-T line card with mini RJ-21 interfaces (EH)
Current Type
Hardware Rev
Num Ports
Up Time
FTOS Version
Jumbo Capable : yes

When to Use CAM Profiling

The CAM profiling feature enables you to partition the CAM to best suit your application. For example:
• Configure more Layer 2 FIB entries when the system is deployed as a switch.
• Configure more Layer 3 FIB entries when the system is deployed as a router.
• Configure more ACLs (when IPv6 is not employed).
• Hash MPLS packets based on source and destination IP addresses for LAGs. See
page 298.
• Hash based on bidirectional flow for LAGs. See
page 299.
: card problem - mismatch cam profile
: online
: E48TF - 48-port 10/100/1000Base-T line card with RJ-45 interfaces (EF)
: Base - 1.1 PP0 - 1.1
: 48
: 0 sec
: 7.6.1.0
: card problem - mismatch cam profile
: online
: E90MH - 90-port 10/100/1000Base-T line card with mini RJ-21 interfaces (EH)
: Base - 0.3 PP0 - 1.1
: 90
: 0 sec
: 8.1.1.0
PP1 - 1.1
PP0 - PP1 -
LAG Hashing based on Bidirectional Flow on
LAG Hashing on
Content Addressable Memory | 287