Installing The Rear Cutting Units To The Lift Arms - Toro Reelmaster 7000-D Operator's Manual

Installing the Rear Cutting Units to the Lift Arms

Cutting Units adjusted for a 1.2 cm (3/4 inch) or Lower Height of Cut
1. Slide the lift-arm pivot shaft
arm
washer
2. Slide the lift-arm yoke
the carrier frame shaft
lynch pin
3. Slide a cutting unit under the lift arm.
4. Slide the lift-arm pivot shaft
onto of the lift arm
lynch pin
5. Repeat this procedure for the other rear cutting
unit.
3466-706A
by removing the lynch pin
.
and washer
and secure it with the
.
and secure it with the
.
out of the lift
and
G420582
onto
G420583
and washer
G420584
Page 3–10 Setup: Installing the Cutting Units