Toro Reelmaster 7000-D Operator's Manual page 111
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Backlapping the Cutting Units (continued)
Backlap lever (front cutting units 4, 1, and 5)
Backlap lever (rear cutting units 2 and 3)
Lapping the Reels and Bedknife
Changing the engine speed while backlapping may cause the cutting units to stall,
which could result in death or serious injury.
• Never change the engine speed while backlapping.
• Backlap only at idle engine speed.
Note:
When backlapping, the front units all operate together, and the rear units operate
together.
1. Ensure that the traction pedal is in the neutral position and the parking brake is
engaged.
2. Start the engine and run it at low-idle speed.
3466-706A
G425459
Reverse rotation (backlap)
WARNING
Page 6–47
Maintenance: Cutting Unit Maintenance
Advertisement
Table of Contents
