Installing The Kickstand; Increasing The Rear Cutting Unit Pivot Angle - Toro Reelmaster 7000-D Operator's Manual

Installing the Kickstand

For each cutting unit, secure the kickstand
the chain bracket

Increasing the Rear Cutting Unit Pivot Angle

Cutting unit 1
Cutting unit 2
Increase the pivot angle of the rear cutting units by
removing the 2 spacers
, and 2 flange locknuts
frames
3466-706A
with the snapper pin
Cutting unit 3
Cutting unit 4
, 2 hex-socket screws
from the carrier
of cutting units 2 and 3.
to
.
G411001
G419225
Cutting unit 5
Reel motor
G419226
Page 3–8
Weight
Setup: Installing the Cutting Units