Positioning the Turf Compensating Spring and Installing
the Hose Guide (continued)
1. If the hairpin
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
2. Remove the 2 flange locknuts (3/8 inch)
and 2 carriage bolts (3/8 x 1-1/4 inches)
that secure the turf-compensator bracket
the cutting-unit frame.
3. Remove the flange locknut (3/8 inch)
securing the bolt
carrier frame, and remove the compensation
spring from the cutting unit.
Note:
from the bolt.
Setup: Installing the Cutting Units
is installed in the rear hole of
to the right tab
Do not remove the flange serrated nut
G410292
to
G402719
of the
G410295
Page 3–3
3466-706 A