NEC UNIVERGE SV9100 Manual page 92
Voice over ip
Hide thumbs
Also See for UNIVERGE SV9100:
- Features and specifications (1403 pages) ,
- Programming manual (954 pages) ,
- Manual (766 pages)
Table of Contents
Advertisement
92
VLAN Settings
It is possible for the SIP MLT to have specific VLAN and Priority settings. It is also possible for the PC uplink
connection to have different VLAN and Priority settings.
The VLAN and Priority settings must be made by programming each individual handset.
Setting VLAN Values for the SIP MLT
1.
Press Menu, then 0 (Config) to enter the terminal program mode.
2.
At the Login screen, enter the user name (default = ADMIN) and password (default = 6633222)
and press the OK softkey.
3.
Press 1 for Network Settings.
4.
Press 6 for Advanced Settings.
5.
Press 1 for LAN Port Settings.
6.
Press 2 for VLAN Mode.
7.
Press 2 to Enable and press the OK softkey.
8.
Press 3 for VLAN ID.
9.
Enter the required VLAN information and press the OK softkey.
10. Press 4 for VLAN Priority.
11. Enter the require VLAN Priority information and press the OK softkey.
12. Press the Exit softkey three times.
13. Press the Save softkey.
14. The handset will reboot and reconnect to the SV9100.
Setting VLAN Values for the PC Port
1.
Press Menu, then 0 (Config) to enter the terminal program mode.
2.
At the Login screen, enter the user name (default = ADMIN) and password (default = 6633222)
and press the OK softkey.
3.
Press 1 for Network Settings.
4.
Press 6 for Advanced Settings.
5.
Press 2 for PC Port Settings.
6.
Press 2 for Port VLAN Mode.
7.
Press 2 to Enable and press the OK softkey.
8.
Press 3 for Port VLAN ID.
9.
Enter the required VLAN information and press the OK softkey.
10. Press 4 for Port VLAN Priority.
11. Enter the require VLAN Priority information and press the OK softkey.
12. Press the Exit softkey three times.
13. Press the Save softkey.
14. The handset will reboot and reconnect to the SV9100.
ToS Settings
It is possible for the SIP MLT to have specific Layer 3 QoS (ToS) values. It is possible to set the SIP
signalling and RTP ToS values independently allowing for different values for each.
There are two ways to set the ToS values in a SIP MLT handset:
By programming each handset through its menu.
By programming the SV9100 which the SIP MLT then reads on registration.
In both cases the QoS value must be set by using a hexadecimal value.
Setting ToS Values using the SIP MLT Menu
1.
Press Menu, then 0 (Config) to enter the terminal program mode.
Advertisement
Table of Contents
Troubleshooting
