NEC UNIVERGE SV9100 Manual page 109

331#
Line key 1
Line key 1
* If default was successful then the terminal is reset with default values. If default
is reset with existing settings.
Handset Programming Factory Default (ITZ-8, ITZ-12, ITZ-24, ITL-6, ITL-8, ITL-
12, ITL-24, ITL-32, ITL-320C)
This must be performed on each handset: -
Enter handset programming by pressing Menu 0
Enter the correct User Name and Password
3. Maintenance Settings
3. Data Clear
Factory Value
OK
Wait.....
Exit
Exit
Save
Web Interface Factory Default (All Terminals)
This must be performed on each handset: -
Browse to the IP address of the handset.
Enter the correct User Name and Password
Maintenance Settings
Data Clear
Factory Value
OK
OK
Wait.....
OK
Save
OK
IP Phone Manager Factory Default (All Terminals)
This can be used to control up to 8 handsets at a time.
Use the Search, Import or Direct function to locate the handsets
Tick the handsets that you wish to connect to and click 'Connect'
Click 'Execute'
Click 'Yes'
Click 'OK'
Click 'Close'
In the 'Command' box choose 'DataReset' and click 'Execute'
Default terminal
Save settings
Result = Pass
Result = Fail
Reset terminal*
Part 2: VoIP Manual
Green Flashing green
Red Red
Red Red
Red Red
109
Off
Off
Green after a delay
Red
failed then the terminal