NEC UNIVERGE SV9100 Manual page 70

70
st
1 DT800 DT700 to register is set to 1 (default)
Configure an SIP MLT and connect to the LAN
The SIP MLT will take port 17 (ext 216 in default)
Port 18 will also be reserved for use by another IP extension.
If a second extension card (e.g. DLCA, LCA) is inserted, it will take ports 19 onwards.
When connecting a SIP MLT, the MAC address (ID) is automatically registered in Easy Edit – Advanced
Items/VoIP/Extensions/DT800 DT700 Setup/DT800 DT700 Terminal Settings. (PRG15-05-02)
If the MAC address is entered manually, prior to connecting the phone, when the phone is connected, it
may (depending on the Register Method) use the port number assigned.
The MAC address is printed on the barcode label on the base of the phone. It is a 12-digit alphanumeric
number, ranging from 0-9 and A-F.
Note: If the port does not have a corresponding extension number assigned to it, the SIP MLT will be
assigned to the next available port which does have an extension number.
If there are no ports with extension numbers available, the SIP MLT with show "Full Port" on the display.
If the extension number is removed from and already registered SIP MLT, it will re-register to the next
available extension number.
If the SV9100 is being used as a DHCP server and has default IP addresses, no configuration is required
on the SIP MLT.
Registration Procedure – Plug and Play
When the Register Mode is set as Plug and Play in Easy Edit - Advanced Items/VoIP/Extensions/DT800
DT700 Setup./DT800 DT700 Hot Desk/DT800 DT700 Logon Type. (PRG10-46-01), the following
information will apply.
Set the Extension Number for the SIP MLT extension against an unused (no associated hardware) port in
Easy Edit -Advanced Items/VoIP/Extensions/DT800 DT700 Setup./DT800 DT700 Hot Desk/DT800 DT700
Logon Feature (PRG11-02)
The SIP MLT should be programmed to register to the GPZ-IPLE card on the SV9100.
When an SIP MLT connects to the SV9100, it is assigned the first available port after the value set in Easy
Advanced Items/VoIP/Extensions/DT800 DT700 Setup/DT800 DT700 Setup/1 st DT800 DT700 to
Edit –
register. (PRG10-46-10)
If static IP addresses or external DHCP server is in use, follow these steps on the handset itself: -
Press Menu 0
User Name - ADMIN
Password - 6633222
OK
Press 1 1 - Choose DHCP on or off (depending on network requirements)Press OK
Press 2 - IP Address of phone (if not DHCP) Type in the required IP address using * for . Press OK.
Press 3 - Default Gateway of phone if required (if not DHCP) Press OK.
Press 4 - Subnet Mask of phone (if not DHCP) Press OK.
Press Exit.