NEC UNIVERGE SV9100 Manual page 88

88
6. Advanced Settings
6. LLDP Settings
1. LLDP Mode
o
2. Auto Setting Mode (Enable/Disable)
o
3. RX Waiting Time
o
4. Transmit Interval
o
5. Hold Multiplier
o
6. Fast Start Count
o
7. Transparent Mode (Enable/Disable)
o
8. Asset ID
o
Note:
Non-display IP Terminals should be configured using the Web interface or Auto Config.
All LLDP configuration items except 'Asset ID' are available via Auto Config in IP Phone Manager.
LLDP information sent from SIP MLT
Example:
Chassis id:
Port id:
Port Description:
System Name:
System Description:
Time remaining:
System Capabilities:
Enabled Capabilities:
Auto Negotiation:
Physical media capabilities:
Media Attachment Unit type:
MED Information:
Serial number:
Manufacturer:
Model:
Asset id:
LLDP information sent from Network Switch
Example (switch type and configuration dependant):
Chassis Subtype
Port Subtype
Time to Live
System Name
System Description
Port Description
Capabilities
Management Address
Media Capabilities
(Enable/Disable)
(1 – 60 Seconds)
(5 – 32768 Seconds)
(2 – 10) (4)
(1 – 10) (3)
(Input an Asset ID)
172.16.0.100
0060.b9xx.xxxx
LAN Port
NEC IP Phone
DT700 Series
xx seconds
Bridge, Telephone
Bridge, Telephone
supported, enabled
100base-TX (Full Duplex)
100base-TX (Half Duplex)
10base-T (Full Duplex)
10base-T (Half Duplex)
10
H/W revision: 9.1.3.4
F/W revision: 4.0.0.0
S/W revision: -
NEC
DT700 Series
ASSET001
18:EF:63:xx:xx:xx
Fa 0/2
xx Seconds
Lab Switch
Cisco IOS V12.2 (55) SE
Fast Ethernet 0/2
Bridge, Router
172.16.255.254
LLDP-MED
Network Policy
(Enable)
(Enable)
(15 Seconds)
(30 Seconds)
(Enable)
(-)
(Terminal IP address)
(Terminal MAC address)
(Assigned in handset config)