NEC UNIVERGE SV9100 Manual page 198

198
Call Park Retrieve – K-CCIS
Feature Description
This feature allows a station user to retrieve Parked Calls at remote sites across K-CCIS. Locally parked
calls can be retrieved from a remote system, connected via K-CCIS, by dialling the Call Park Hold Group
Number, plus the park orbit location.
System Availability
Terminal Type:
All Terminals
Required Components:
GPZ-IPLE
Operating Procedures
Retrieve Park Call at remote location:
1. Go off-hook, and wait for internal dial tone.
2. Dial the Call Park Retrieve Access Code 861 (default) + Park Hold Group Number (1~64) + Park
Orbit Number (1~64) of the call to be retrieved. Call
(Park Retrieve access codes cannot be the same at all locations in the K-CCIS Network.)
3. Talk with party.
Service Conditions
General:
A different Call Park Retrieve Access Code must be programmed for each system in the K-CCIS
network.
The Park Group Number and Park Orbit Number must be dialled immediately following the Park
Retrieve Service Code.
When two or more stations attempt to retrieve the parked call, only one station can retrieve the call.
A station connected to a PBX can retrieve a parked call in an UNIVERGE SV9100, but the station
connected to the UNIVERGE SV9100 system cannot retrieve a parked call in a PBX.
A Park Hold key cannot be used to retrieve a parked call from a distant system.
F-Routes are required to route Call Park Retrieve Access Code to proper system in the K-CCIS
network.
When a remote location retrieves a call from another location, the call is treated as if it were
transferred from the distant location.
SMDR reports the retrieved call from the distant location as if it were a transferred call.
When a call that has Caller ID Information is retrieved at the distant location the Caller ID
information is treated as if it were a transferred call.
Link Reconnect operates when the trunk is retrieved back to the origination system.
Restrictions:
A Call cannot be placed into remote systems Call Park Location.
Call Park Retrieve – K-CCIS is only a Key System-to-Key System supported feature.
The digit (# or *) cannot be used in conjunction with IP K-CCIS.
When the UNIVERGE SV9100 is connected to the Electra Elite IPK II, the maximum digits
assignment in the UNIVERGE SV9100 is determined by Program 44-05-09.
Call Park Searching is supported in the local system only.
Related Feature List
Call Park – System