Table of Contents
Advertisement
6-3 Autolocation Controls
SHIFT
To autolocate the tape to a cue point
ROL
1 Press RCL.
2 Enter the desired MEMORY NO. with the numeric keys.
The cue point stored in that register will be recalled into the
LOCATE TIME window.
Press LOC.
ly
a
Go
N
The tape will automatically be located to the time point currently
shown in the LOCATE TIME window, or to a point optionally set
time lower than that time point.
At the end of autolocation function, the tape will stop unless
AUTO PLAY is previously activated.
cree
Ill
Auto play
a
"etre
Pressing AUTO PLAY after or before LOC will start playing
[
whenever any autolocation function is complete.
Repeat play between two memory points
Repeat play disregards whatever Locate Preroll Time has been
entered.
To set a play loop
1 During play, capture the desired start point of loop by pressing the
Y key. That time point will appear in the LOCATE TIME window.
You can alternatively enter the start time with the numeric keys.
i")
ls
Press STR.
Press START to store the LOCATE TIME into memory as the start
point of loop.
(J
Go
END
4 In a similar way, capture the end point, and store it into memory
by pressing STR again then pressing END.
ES
6-8
Chapter 6 Operation Using the RM-D800 Remote Control Unit
Advertisement
Table of Contents
