Table of Contents
Advertisement
chapters
lll
5-6 Striping Time Code (With the DABK-801)
LP
Dig
gw
a
Oe
ee
A
SE
gl
Dubbing procedure
TAL IN
ae
L
x2)
IGTAL IN
yy
Z
©
aes
Al Tg Rec
9H
\
| GHASE
®
Vly
ly
—@—Piuy
—@pecorp
MACHINE
MENU
ly
o-
| N
Ci
5-28
Chapter 5 Operation
Without the RM-D800
1 Press DIGITAL IN on the target PCM-800 to put this into Digital
Input mode.
Hold the upward key (A) and press DIGITAL IN on the source
PCM-800. "DIGITAL" will flash in the display window.
3 Insert the master tape in the source machine, and a formatted
record tape in the target machine.
On the part of the source machine: check to see that all the eight
REC FUNCTION indicators are off, and the TC REC indicator
too.
O1
On the part of the target machine: press the REC FUNCTION
keys 1-8, to turn on the associated indicators, then press TC REC.
o
Press CHASE on the target machine.
7 Hold RECORD and press PLAY on the source machine, which
causes the source machine to start playing and the target machine
to start recording.
In this case, the source PCM-800 cannot go into record mode
regardless of whether the source tape is record-protected or not.
If it is record-protected, the RECORD indicator on the source
PCM-800 does not light.
With the RM-D800
1 Press MACHINE.
"Select" will show in the LOCATE TIME window.
2 Press 2 on the keypad (if the target machine is ID- numbered "1";
or press 3 if it is numbered "2" and so on).
3 Press MENU until the LCD screen reads:
Input Select
Analog
4 Press either the + or - key to change the "Analog" to "Digital."
Ol
Press TC REC. Its indicator will start flashing.
6 Press REC FUNCTION 9-16
(or others depending on the machine
currently selected).
Advertisement
Table of Contents
