GE Voluson S6 Basic User Manual page 386

Measurements and Patient Worksheets (Reports)
11.1.2.3 Generic Volume Measurement
11.1.2.3.1 3 Distances
Note
Note
11-10
1. To measure volume of an ovoid using three distances, select the [3 Dist] item in the
menu area. A cursor appears on the screen.
2. Move the cursor to the start point of the measurement and press the right or left trackball
key [Set] to fix the marker. A second cursor appears.
3. Move the second cursor to the end point of the first measurement and press [Set] again.
To re-adjust the start point, press the upper trackball key [Change] before completing the
measurement. This alternates the control from one cursor to the other.
4. Measure the second distance as described above.
•
When using single image mode, measure the two distances. Press [Freeze] to
return to scan mode and scan the second image. Press [Freeze] again. A new
cursor for the third distance measurement appears.
•
If you have scanned the second image in Dual mode previously, you can measure
the third distance within this second (half) image.
5. Perform the measurement of the third distance in the same manner.
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4