Marking The Outer Grass Baskets; Adjusting The Transport Height - Toro Greensmaster 3250-D Operator's Manual

1. Mounting bolts
8. Coat the motor spline shaft with clean grease
and install the motor by rotating the motor
clockwise so that the motor flanges clear the
studs. Rotate the motor counterclockwise until
the flanges encircle the studs
9. Tighten the mounting bolts
9
Marking the Outer Grass
Baskets
No Parts Required
Procedure
To assist in aligning the machine for successive
cutting passes, do the following procedure to the No.
2 and No. 3 cutting unit baskets:
1. Measure in approximately 12.7 cm (5 inches)
from the outer edge of each basket.
2. Either place a strip of white tape or paint a line
onto each basket paralleling the outer edge of
each basket (Figure
Figure 11
2. Drive motor
(Figure 11).
(Figure 11).
12).
g008420
1. Alignment strip
2. Approximately 12.7 cm (5
inches)
10
Adjusting the Transport
Height
No Parts Required
Procedure
Check the transport height
and adjust it if required.
1. Park the machine on a level surface.
2. On cutting units equipped with a offset lift hook
(Figure 13
the top of the carrier frame adjusting screw to
the back of the carrier frame is 25 mm (1 inch).
If the distance is not 25 mm (1 inch), proceed
to step 4.
15
Figure 12
3. Cut grass on right
4. Keep focal spot 1.8 to 3
m (6 to 10 ft) ahead of the
machine.
(Figure 14 and
inset), verify that the distance from
g005115
Figure 15)