Installing The Roll Bar; Reducing The Tire Pressure - Toro Greensmaster 3250-D Operator's Manual

to the negative (–) terminal of the battery and
secure them with the bolts and nuts
Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
WARNING
Incorrect battery cable routing could damage
the tractor and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
1. Negative (-)
2. Positive (+)
3

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4
Bolt (5/8 x 4-1/2 inch)
4 Locknut (5/8 inch)
Procedure
1. Position the roll bar so the top of the tube is
curved toward the front of the machine
7).
(Figure
Figure 6
6).
1. Roll bar
2. Bolt (5/8 x 4-1/2 inch)
g005098
2. Lower the roll bar onto the frame, aligning it with
the mounting holes
3. Secure each side of the roll bar to the frame
with 2 bolts (5/8 x 4-1/2 inches) and locknuts as
shown in
4. Torque the fasteners to 183 to 223 N∙m (135 to
165 ft-lb).
4

Reducing the Tire Pressure

No Parts Required
Procedure
The tires are over-inflated at the factory for shipping
purposes. Reduce the pressure to the proper levels
(Figure
before starting the machine. Refer to
Tire Pressure (page
12
Figure 7
3. Locknut (5/8 inch)
(Figure 7).
Figure 7.
39).
g019975
Checking the