Adjusting The Mirrors; Aiming The Headlights - Toro Groundsmaster 5910 Operator's Manual

Figure 32
1. Left, front, outside caster
arm
2. Left, front, inside caster
arm
6. If the inside edge is still too high, remove an additional
shim from the bottom of the front, inside caster arm
of the side mower deck and 1 shim from the front,
outside caster arm of the side mower deck
and Figure 32).
7. If the inside edge of the side mower deck is too low
relative to the outside edge of the front mower deck,
add 1 shim (1/8 inch) to the bottom of the front, inside
caster arm on the side mower deck
Figure 32).
Note: Check the measurement between the outside
edges of both side mower decks and the inside edge of
the side mower deck to the outside edge of the front
mower deck again.
8. If the inside edge is still too low, add an additional shim
to the bottom of front, inside caster arm of the side
mower deck and 1 shim to the front, outside caster arm
of the side mower deck.
9. Once the cutting height matches at the edges of
the front and side mower decks, verify that the side
mower-deck pitch is still 7.6 mm (0.3 inch).
3. Right, front, inside caster
arm
4. Right, front, outside caster
arm
(Figure 31
(Figure 31 and

Adjusting the Mirrors

Rear-View Mirror
While sitting in the seat, adjust the rear-view mirror to attain
the best view out of the rear window. Pull the lever rearward
to tilt the mirror to reduce the brightness and glare of light
(Figure 33).
1. Side-view mirrors
2. Rear-view mirror
Side-View Mirrors
While sitting in the seat, have another person adjust the
side-view mirrors to attain the best view around the side of
the machine (Figure 33).

Aiming the Headlights

1. Loosen the mounting nuts and position each headlight
so that it points straight ahead.
Note: Tighten the mounting nut just enough to hold
the headlight in position.
2. Place a flat piece of sheet metal over the face of the
headlight.
3. Mount a magnetic protractor onto the plate.
4. While holding the assembly in place, carefully tilt the
headlight downward 3° then tighten the nut.
5. Repeat this procedure on the other headlight.
31
Figure 33
3. Lever