Table of Contents
Advertisement
2. INSTALLATION
2.6 Installation and removal of MR-D30
WARNING
CAUTION
Before installing or removing MR-D30, turn off the power and wait for 15 minutes
or more until the charge lamp turns off. Then, confirm that the voltage between P+
and N- is safe with a voltage tester and others. Otherwise, an electric shock may
occur. In addition, when confirming whether the charge lamp is off or not, always
confirm it from the front of the servo amplifier.
Avoid installing and removing MR-D30 repeatedly. Any contact failure of the
connector may be caused.
Avoid unsealing MR-D30 to be free of dust and dirt against the connector except
installing. Make sure to use the pre-packing when storing.
Avoid using MR-D30 of which the hook and knobs for fixing are damaged. Any
contact failure of the connector may be caused.
When mounting/dismounting MR-D30 to/from MR-J4-500_-RJ to MR-J4-22K_-RJ
and MR-J4-350_4-RJ to MR-J4-22K_4-RJ servo amplifiers, avoid dropping out
the installing screw inside it. Otherwise, it may cause a malfunction.
When mounting MR-D30 to MR-J4-500_-RJ to MR-J4-22K_-RJ and MR-J4-
350_4-RJ to MR-J4-22K_4-RJ servo amplifiers, avoid damaging the control board
by the fixing plate. Otherwise, it may cause a malfunction.
Make sure to tighten MR-D30 with the enclosed installing screws when installing.
POINT
The internal circuits of the servo amplifier and MR-D30 may be damaged by
static electricity. Always take the following precautions.
Ground human body and work bench.
Do not touch the conductive areas, such as connector pins and electrical
parts, directly by hand.
2 - 5
Advertisement
Table of Contents
