Advertisement
7 7 . . 1 1 . . 3 3 . . 1 1 1 1 S S i i m m u u l l a a t t o o r r
Before a build, it is advised to run a simulation of the build in EBM Control.
This could be done on the machine computer or a workstation.
There are two types of simulations:
S S t t a a n n d d a a r r d d S S i i m m u u l l a a t t i i o o n n
The standard simulation will go through the build layer by layer and per-
form all the calculation that will be done during the actual build.
The simulation allows you to verify that the job will be successfully ana-
lysed during the build.
T T i i m m e e A A p p p p r r o o x x i i m m a a t t i i o o n n
The time approximation only performs the calculations for a limited amount
of layers and extrapolates the values for the remaining layers.
This type of simulation is only intended to quickly give a rough estimate of
the build time for the chosen build. It will n n o o t t detect any flaws in the build.
02
OM-710430
en-GB
131
Advertisement
