Enable Ssh/Sftp; Application Credits (Credit Key) - ABB RMC-100 User Manual

8. Type the register location for the array into the Array Register field if the Plot Type is Array.
Click Send to save.
9.
10. Verify that the plot displays on the LCD.
11. Repeat steps 1 to 10 to configure plots for additional display items, if necessary.
IMPORTANT NOTE: The shape of a plot differs based on the type of value and how the value
fluctuates over time. Constant values, or values with little variation, are straight lines. Values with
greater fluctuation have plots with greater contrast.
5.5

Enable SSH/SFTP

SSH/SFTP servers require a private key for authentication. The keys are in a protected storage
location in the firmware (flash) and remain unchanged by any software updates.
Customer access to the SFTP is read-only. SSH access is not available to the customer. Customers can
copy files from the RMC but cannot write or send files to the RMC.
The following folders are available to copy or download:
–
Crash dumps
–
Firmware: Main Totalflow application (App), factory startup (cold) configuration, and startup
(cold) configuration
–
Logs: System and device loader log files
–
tfData: Running (warm) configuration files
IMPORTANT NOTE: SSH/SFTP services are disabled by default for security. Perform this procedure
only if required and you are an advanced user. Before enabling, see section
(recommended), or contact technical support.
SSH/SFTP access is TCP/IP based. Enable and configure Ethernet with valid IP parameters
To enable the SSH/SFTP services on the RMC:
1. Click Communications on the navigation tree.
2. Click Network to display the Network tab.
3. Click SSH/SFTP Service (Port: 9696) to enable the services.
4. Click Send to save the configuration.
5. Click the Ethernet tab.
6. Click Network Adapter to enable Ethernet.
7. Type valid network parameters into each of the fields (IP Address, Default Gateway, and
Subnet Mask). See section
information.
8. Click Send to save the configuration.
9. Click Help to display the Ethernet Tab topic for more information to establish a read-only SFTP
connection.
5.6

Application credits (credit key)

ABB provides a secure USB flash drive containing four credits to activate application licenses. If this is
not enough to activate all required applications, call the ABB main office on the last page of this
manual to purchase additional credits.
Credit key actions include:
–
Add more credits to the credit key.
–
Transfer credits from an ABB Totalflow device to the credit key.
–
Transfer credits from the credit key to an ABB Totalflow device.
–
Move credits from one credit key to another credit key.
–
Move credits from one ABB Totalflow device to another ABB Totalflow device.
The only program that can write to or read the USB flash drive is PCCU32.
If the RMC runs an unlicensed application, this appears on any generated reports. The RMC logs
unlicensed use in the Event Log at the top of each contract day. Unlicensed applications also cause the
RMC to connect more slowly than normal.
At the Station Setup screen, click the App licensing tab and click Help for information about
maintaining the credit key.
9 6 | R MC-1 00 | 2 10 55 5 2MN A E
4.4.2 Enable serial port switched output power
6 Configure security
for more